"Tools, Steps and Tips To Install The Exhaust System on 2003 Acura RSX"

2003 Acura RSX Exhaust

Currently I’m trying to install a new exhaust system on my 2003 Acura RSX. Does anyone know what kind of tools that I need to use, and also the installation step?

Answer: You will need an 12mm, 14mm ratchet and socket and also floor Jack and jack stands or an automotive lift to do it. Following bellows is step by step on how to install the exhaust system on your Acura RSX year 2003.

Step 1: Raise up and support the car and start by removing the stock muffler. You do this by removing the two 12mm bolts right in front of the suspension. Save all rubber hangers. Tip: If you only have jack stands, raise up the right side of the car. This will give you the greatest level of access to the entire exhaust system.

Step 2: Remove the remained of the exhaust by removing the 14mm bolts at the cat or test pipe. These bolts are on pretty tight, so be prepared. Save all rubber hangers.

Step 3: Install the resonator onto the rubber hangers.  You want to install this first to prevent the middle pipe from bending the cat or test pipe.

Step 4: Install the middle pipe to the resonator and to the cat or test pipe using the supplied gaskets and hardware. Do not tighten down the bolts, leave them a little lose to allow for future adjustment.

Step 5: Install the muffler using the supplied gasket and hardware.

Step 6: Now you tighten everything down as much as you can.